Licensed & Insured 7 Days · 7a–9p Bergen County, NJ
Home/Gym Locker Room Guide

Gym Locker Room Odor, Mold and Slick Floors: Telling a Cleaning Problem From a Building Problem

By Chris, Owner

Published November 9, 2026

The locker room was cleaned and dried, and a short while later a member mentions the smell again, or the dark spots are back along the shower caulk, or someone slides near the benches. Suspecting the cleaning is reasonable, and sometimes the suspicion is right. In many cases, though, the symptom is being fed by something the cleaning never reached.

A useful test, and it is reasoning rather than a published standard, is what happens after a thorough clean. A symptom that clears and stays away for a while points to soil on a surface. A symptom that comes back soon after was being fed by a source the clean did not touch, with one exception worth knowing: a film left by the cleaning product itself returns with every clean, which makes a slick floor the one complaint where the clean can be the cause. That source usually sits in one of four places: the air (humidity and exhaust), the water path (drains, trap seals, venting, standing water), the materials (grout joints, caulk, the tile surface), or the way the room is used (damp towels and clothing, shared items, bare feet). In a locker room, moisture is the first thing to check.

Locker rooms are built to get wet, and the air carries that water

The U.S. EPA's Mold Remediation in Schools and Commercial Buildings guide puts it in one line: "The key to mold control is moisture control." A second EPA document, Moisture Control Guidance for Building Design, Construction and Maintenance (EPA 402-F-13053, December 2013), names locker rooms among the parts of a building designed to be wet from time to time, and it lists showers and wash water on floors as sources of indoor humidity, along with the building's occupants.

The same guidance explains that "When humid air contacts a surface that is cold enough, the water vapor in the air will condense onto that cold surface." A ceiling or exterior wall that keeps condensing keeps getting wet, however recently it was wiped.

On the air side, the control is exhaust. EPA's moisture guidance says that when an exhaust fan removes highly humid air from showers, the indoor humidity load is reduced. The New Jersey Department of Health's mold page makes the connection for bathrooms: mold problems from shower steam can be controlled in part by using an exhaust fan when showering.

A practical check is whether the exhaust fans in the shower and locker areas run at all, what turns them on (a switch, a timer, the lights), whether the grilles are blocked, and whether the room still feels heavy and damp well after the last shower of the evening.

Tracing a returning odor by the clue each source leaves

A dry trap seal. EPA's Indoor Air Quality Tools for Schools Reference Guide (EPA 402/K-07/008, January 2009) lists "Dry drain traps that allow the passage of sewer gas" among typical sources of indoor air pollutants, and the mechanism is covered in our article on why a quiet restroom can still develop an odor. The clue is a sewer smell concentrated at a drain that rarely sees water: a floor drain away from the showers, or a stall that has been out of service.

Venting and the drain line. Columbia University's environmental health and safety office, in a fact sheet on lab sinks and floor drains, notes that "if the vent is broken or blocked, odors can permeate into the surrounding environment." Separately, and as my own reasoning rather than anything that fact sheet says, a drain that smells even with water standing in its trap points past the trap seal, either to buildup inside the drain line or to the venting, and that is a plumber's question. Small flies at a shower drain are a different signal. Ohio State University Extension's fact sheet on drain flies says they breed in "bacterial muck, slime or gelatinous film" that builds up on the sides of drains; it addresses the flies and does not discuss odor.

Damp towels and clothing. The University of Missouri Extension's guidance on mildew in fabrics is written for households, but its points carry: fabrics that dry slowly can turn sour and musty, which MU Extension calls a sign of mold growth, and "A closed bag, dampness and hot summer weather make ideal growing conditions for molds." A smell that is strongest where used towels collect, or where wet clothing is left on benches, points to fabric sitting damp.

Exhaust that is off or not reaching the showers. In an April 2025 indoor air quality assessment of Timony Grammar School in Methuen, the Massachusetts Department of Public Health observed that "Blocked exhaust vents do not function well to remove stale air." The clue is a room that smells stale and damp all over, rather than at one spot.

Fragrance does not belong on this list, because it changes the smell without changing the source. The Environmental Health and Safety office at UMass Amherst notes that people turn to air fresheners "to mask or remove unpleasant odors," and cautions that even with a product claiming to clean the air, "the source of odors, bacteria, or other allergens would not be addressed."

Cleaning's part in all of this is the soil on surfaces such as floors, benches, walls and fixtures.

Mildew that returns to grout, caulk and ceilings

EPA's commercial mold guide is direct about growth that is cleaned while the water is left alone. Chapter 3 warns that unless the source of the moisture problem is addressed, "the mold problem may simply reappear." It also says "Porous materials that are wet and have mold growing on them may have to be discarded," and lists the top of ceiling tiles among the hidden places growth can sit. Given that list, spots on the face of a dropped-ceiling tile may be only part of what is there.

Tile walls and floors are also less watertight than they look. The U.S. Department of Energy's Building America Measure Guideline: Water Management at Tub and Shower Assemblies (December 2011) is written for residential tubs and showers, but its point carries: "the myth persists that the finish surround on a bathtub or shower wall is 100% waterproof." Water can pass, it explains, "through the grout joints or through transitions between materials," and the caulking at the base of a surround should not be assumed tight at all times. Cracked grout, caulk pulling away at a corner or the floor line, and staining that keeps returning along a transition are signs to have the assembly looked at. Whether that grout or caulk needs repair is a question for whoever maintains the building, and the lease is where to check who that is.

On testing, the CDC's National Institute for Occupational Safety and Health, on its mold testing and remediation page, says it does not recommend routine air sampling for mold and that measured concentrations cannot be interpreted in relation to health risks. EPA's commercial guide adds that "In most cases, if visible mold growth is present, sampling is unnecessary." If you bring in a mold company, the New Jersey Department of Health says there are no state certification programs for companies that perform mold work. Whatever firm you bring in, ask how it will find and stop the water source.

Slick floors after cleaning: residue, surface or drainage

Slick floors divide into two groups, and only one of them is a cleaning question.

The first is residue. NIOSH's guide to preventing slips, trips and falls in wholesale and retail trade establishments (Publication No. 2013-100) advises: "Use soap that does not leave slippery residue." The UK Health and Safety Executive's guidance on cleaning says "cleaning affects the surface properties of the floor" and points to "using the right amount of the right cleaning product." The wrong product, or the wrong amount of it, can leave residue that makes a floor slippery.

The second group is the surface and the drainage. The tile industry's slip-resistance test standard, ANSI A326.3-2021, lists locker rooms and public showers among possible uses for a wet-area category whose rating the tile manufacturer declares, subject to the specifier's determination and the standard's own criteria. It sets no single friction value for shower floors, because suitability depends on the size and drainage of the shower, and the standard says its measurement does not predict whether a person will slip. It also names soap among the contaminants that change the measured value, describes standing water on floors not properly sloped for drainage, and notes that friction on installed flooring can change over time with wear.

Mats sit in the same group. The National Safety Council's Data Sheet 595 on floor mats and runners warns that "Grease or water can make mat surfaces slippery" and that mats can develop curled or raised edges, and NIOSH flags a mat that is too small or saturated as one to replace. A mat helps only while it drains and lies flat.

My own reading, offered as reasoning rather than anything the standard states: if the floor is still slick after a clean-water rinse leaves no film on it, residue becomes less likely and the tile surface becomes the question. If the slick spot is always the patch where water stands after the evening rush, that is a drainage question. Routine care for porcelain and ceramic tile is covered in our floor maintenance guide.

A clean-looking room is no answer to a skin infection report

Skin infection reports from members are a different kind of symptom, and CDC frames them around contact with people, shared items and surfaces. CDC's guidance for athletic facilities says "MRSA can spread through skin-to-skin contact and by touching contaminated surfaces (places where the germ may live)," and that it "can spread in athletic facilities due to shared equipment and close physical contact among athletes." CDC's prevention advice for athletic programs and athletes treats cleaning shared surfaces that touch bare skin as one measure among several, alongside hand hygiene, showering after exercise, laundering and thoroughly drying towels and clothing, not sharing towels or razors, and keeping cuts covered. Its general MRSA prevention page adds: "Even when a surface appears clean, it can still have germs."

For fungal infections, CDC's page on what causes ringworm lists "Contact with contaminated surfaces like locker room floors" and "Walking bare feet in locker rooms," and its prevention guidance says to "Wear shoes or sandals in locker rooms and public showers." The NIH's MedlinePlus entry on athlete's foot says "The fungus thrives in warm, moist areas" and that it can pass through contact with items such as "shower or pool surfaces."

So the manager's levers are as much policy and supplies as cleaning: a footwear rule in the showers, no shared towels, soap, hand rub and bandages kept stocked (CDC tells athletic programs to keep these available), and a clear expectation that members keep open wounds covered.

On reporting, CDC's athletic-facility guidance tells programs to refer an infected athlete to a healthcare provider. Its guidance for schools and daycares adds that multiple infections should be reported to the local health department, and the New Jersey Department of Health's guidelines for skin infections in contact sports, written for school athletic programs, say the same. NJDOH guidance for schools also says single MRSA infections should not be reported to the state. For a gym, my suggestion is that if several members report skin infections close together, the local health department is the call to make.

Notes to have ready before the next call

Before the next call to your cleaning provider, a plumber, an HVAC contractor or the landlord, write down:

  • Which symptom: odor, mildew, a slick floor, or infection reports.
  • When the area was last cleaned, what improved, and how soon the complaint returned as you have observed it. Photographs of the spot help.
  • Where it concentrates: one drain, one stall, the ceiling over the showers, the towel area, one stretch of floor.
  • Whether the exhaust fans run, what turns them on, and whether the grilles are clear.
  • Any leak, drip, condensation or ponding you have noticed, and where.
  • Who maintains the exhaust fans, drains and plumbing. That depends on your lease, so check it.

Keep what you saw separate from what you suspect. Water collecting beside a shower is an observation; a failed floor assembly is an explanation that someone still has to confirm.

If the notes point to surface soil or residue, that is a scope conversation. Our gym cleaning page sets out what our locker-room cleaning covers: locker rooms and showers cleaned, disinfected and dried down. Every Bergen contract carries a written scope, and changes to it are documented and approved before they take effect. If you want that scope priced for your facility, request a quote.